QDso中英文明书.docVIP

使用说明书 User Manual 小Q示波器/QDso Introduction QDso is equipped with 3.5-inch TFT, 1000mA lithium battery, real-time sampling rate of 200M, 40M bandwidth Pocket handheld oscilloscope. Hardware specification Input Max sample 200MS/s Channels 1 Bandwidth 40MHz analog bandwidth Vertical resolution 8bit Gain range 10mV-5V; -5V~+5V（probe X1）（10mV-10V, 1,2,5 step） 100mV-50V; -50V~+50V（probe X10） DC accuracy +/-3% Impedance 1MΩ 25pF Coupling DC Display Mode Y-T Input Protection Diode，50Vpk Timebase Timebase range 1ns~100ms (1,2,5 step) Buffer Size 4K Trigger Mode Auto、Normal and Signal Type No、Rising edge、Falling edge and edge Autoset Yes Level Yes Math measurements Vmin、Vmax、Vpp、Vrms and Frequence Cursor Max 2 Physical Display 3.5inch 24Bit true color TFT 320*240 Battery 1000mA lithium battery(About 2 hours of continuous work) Dimensions 110*75*13(mm) The use of introduced Power switch Power input Signal probe input Standby / menu Pause Auto Move Left/Horizontal Zoom In Ok/Switch Move Right/Horizontal Zoom Out Move Top/Vertical Zoom In Move Bottom/Vertical Zoom Out  Power Used to open and close the main power Signal input Connect the probe to position Out Power Input Charging or using an external power supply, the power cord connected to the Charging Note: machine can charge in the shutdown state. Standby Press button2s-3s into standby mode, and once again a long press wake Waveform measurements Auto: button ⑥, Start the automatic detection of the oscilloscope Pause: button ⑤, Pause/Run oscilloscope Wave Move, Zoom: State switch: button ，switch to zoom, move state；The top left of the screen‘M’means into the move state,‘Z’means into the zoom state，‘C1’means into the cursor 1 move state，‘C2’means into the cursor 2 move state. Move State: move wave left and right or the selected cursor; move vave top and bottom or the selected cursor. Zoom State: Zoom Horizontal；Zoom Vertical. Button ④switch into menu mode