2014大庆中学试题.docVIP

2014年大庆市中考数学试题 一、选择题（本大题共10小题，每小题3分，共30分．．．．．．．．．．．．．．．．． A B C D 5．．．．．．．．．． 9题图 6题图 7．A．5.5公里 B．6.9公里 C．7.5公里 D．8.1公里 8．上有两点A（x1，y1）、B（x2，y2），若y1＞y2，则x1-x2的值是（ ） A．正数 B．负数 C．非正数 D．不能确定 9．A． B． C． D． 10．–y2｜，则｜AB｜与‖AB‖的大小关系为（ ） A．｜AB｜≥‖AB‖ B．｜AB｜＞‖AB‖ C．｜AB｜≤‖AB‖ D．｜AB｜＜‖AB‖ 二、填空题（本大题共8小题，每小题3分，共24分．．，则的值为________．．． 13．的解为．．．．．．．．，F是DA延长线上一点，G是CF上一点，且∠ACG=∠AGC，∠GAF=∠F=20°，则AB=________．．． 15题图 17题图 三、解答题（本大题共10小题，共66分，请在答题卡指定区域内作答，解答时应写出文字说明，证明过程或演算步骤） 19． 20．的整数解．．，求的值．．．． 23．的图象与x轴相交于点A（-2，0），与y轴交于点C，与反比例函数在第一象限内的图象交于点B（m，n），连结OB，若S△AOB=6，S△BOC=2．． 24． 25．的图象与x轴只有一个公共点，求m的值．．．的长度． 27．．． 28．．． appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts bea