琼山区2012小学英语备考研讨会工作简报.docVIP

琼山区2012年小学英语备考研讨会工作简报2012年3月30日，琼山区2012年小学英语备考研讨会在海之南外国语实验学校隆重举行。 出席本次研讨会的有海口市教育研究培训院吴允秀主任、琼山区教育局教研室梁秋敏教研员、海之南外国语实验学校杨汉霞校长及区各小学全体六年级英语教师共65人。本次研讨会议程为：（一）由海之南外国语实验学校刘英老师展示一堂六年级复习观摩课。（二）观课教师针对复习课的有效性展开互动研讨。（三）海口市教育研究培训院吴允秀主任对如何上好小学英语备考复习课进行专题指导会议剪影如下： 备考研讨会主持人---海之南外国语实验学校叶琳琳老师 海之南外国语实验学校杨汉霞校长致欢迎词 备考研讨会议程（一） 六年级复习观摩课现场 备考研讨会议程（二）参会教师在互动研讨 备考研讨会议程（三）海口市教育研究培训院吴允秀主任进行专题指导 认真听课的老师们 coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and then gently with copper home, not too loose or too tight. Bolt Assembly is finished, symmetrical tightening all bolts to 30%, 50%, 70%, 100% force