绿曼与美国大豆会共同举办蛋鸡养殖技术论坛.doc

2011年1月12日绿曼公司饲料事业部与美国大豆协会在茌平县共同举办蛋鸡养殖技术论坛，参会蛋鸡养殖场近80余个，会议由家禽饲料部河北区域刘经理主持，第一阶段由美国大豆协会饲料技术主任程宗佳博士讲营养与加工技术对家禽免疫与疾病防控的价值，其中介绍国内外多种新技术；第二阶段由绿曼公司饲料营养专家曾凡章讲饲料的免疫与保健（解析绿曼饲料）；第三阶段为绿曼家禽饲料部魏总作会议总结，并主持有奖问答，与会养殖场业主积极参与回答问题，中奖者得到一份美国大豆协会技术光盘。 coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and then gently with copper home, not too loose or too tight. Bolt Assembly is finished, symmetrical tightening all bolts to 30%, 50%, 70%, 100% force, and check the coupling flutter and before connecting the circle gradually changes its value should be less than 0.02mm. Tightening torque of the coupling