零星雨多功能卡文使用说明..doc

多功能卡接口说明 1、远程控制大屏电源 有信号传输到功能卡上面时，功能卡的接线端会相通产生回路，power1、power2、power3可以用于此功能。（如下图3） FAN1、FAN2用于控制风扇、空调 2. 内部温度、外部温度 内部温度通过功能板上面的热敏电阻反馈回来的温度。（RT2） 外部温度通过10P排线的3、4脚连接的热敏电阻取得，它可以通过温、湿度播放窗到屏上去。 3. 自动亮度 它由10P排线所接的光敏电阻所取得，根据天气变化的光度来决定屏的亮度。 4. 声音传输（必须配用802型发送卡） 从电脑声卡接到发送卡上（音频线），发送卡再通过网线或者光纤传到功能卡上，再由功能卡的音频输出口连接功放。 5. 连接视图 6. 设置版面 首先打开LED演播室，点击设置——软件设置——在键盘上输入“linsn”——密码168进入接收卡设置界面。 选择允许功能卡亮度选项。 2. 选择允许亮度自动调节就是让功能卡根据外部环境亮度来调节LED大屏幕亮度。 7．参数设定 图3注：A1、A2为交流接触器的控制端，可以用万用表量出. 220V远程控制大屏电源。(如下图) coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts ap