毕业设计论文--基于51单片机的密码锁设计程序.docVIP

#include 1302.h void write_ds1302_byte(uchar dat) { uchar i; for(i=0;i8;i++) { T_IO=dat0x01; T_CLK=1; T_CLK=0; dat=dat1; } } uchar read_ds1302_byte() { uchar i; for(i=0;i8;i++) { ACC=ACC1; ACC7=T_IO; T_CLK=1; T_CLK=0; } return (ACC); } void write_ds1302_dat(uchar addr,uchar dat) { T_EN=0; T_CLK=0; T_EN=1; write_ds1302_byte(addr); write_ds1302_byte(dat); T_CLK=1; T_EN=0; } uchar read_ds1302_data(uchar addr) { uchar date; T_EN=0; T_CLK=0; T_EN=1; write_ds1302_byte(addr); date=read_ds1302_byte(); T_EN=0; T_CLK=0; return (date); } void set_real_time(uchar *pclock) { uchar i,addr=0x80; EA=0; write_ds1302_dat(0x8e,0x00); for(i=0;i7;i++) { write_ds1302_dat(addr,*pclock); pclock++; addr+=2; } // write_ds1302_dat(0x8e,0x80); EA=1; } void get_real_time(uchar Curtime[]) { uchar j; uchar address=0x81; EA=0; for(j=0;j7;j++) { Curtime[j]=read_ds1302_data(address); address+=2; } EA=1; } #ifndef __1302_H__ #define __1302_H__ #include reg52.h #includeintrins.h #define uchar unsigned char #define uint unsigned int sbit T_IO=P2^5; sbit T_CLK=P2^4; sbit T_EN=P1^0; sbit ACC0=ACC^0; sbit ACC7=ACC^7; void write_ds1302_byte(uchar dat); uchar read_ds1302_byte(); void write_ds1302_dat(uchar addr,uchar dat); uchar read_ds1302_data(uchar addr); void set_real_time(uchar *pclock); void get_real_time(uchar Curtime[]); #endif #include delay.h #include 1602.h void lcd_busy_wait() /*LCD1602 忙等待*/ { lcd_rs_port = 0; lcd_rw_port = 1; lcd_en_port = 1; lcd_data_port = 0xff; while (lcd_data_port0x80); lcd_en_port = 0; } void write_com(uchar command) /*LCD1602 命令字写入*/ { lcd_busy_wait(); lcd_rs_port = 0; lcd_rw_port = 0; lcd_en_port = 0; lcd_data_port = command; lcd_en_port = 1; lcd_en_port = 0; } void write_data(uchar dat) { lcd_busy_wait(); lcd_rs_port=1; lcd_rw_port =0; lcd_en_port=0; P0=dat; lcd_en_port=1; lcd_en_port=0; }