第10章装配图2答案_拆画气缸缸体.docVIP

10-15 读装配图：Ф50H8直接从装配图摘出；螺孔尺寸依据件12螺钉的规格尺寸M6大于20到80的倒角C1 1×45° ，所以确定Ф50H8孔口倒角C1；其余尺寸从装配图量取后取整数。 粗糙度Ra数值依据标准规定的表面粗糙度选用表格选取。 5. 填写标题栏：姓名、日期、比例、零件名称、零件材料、绘图人单位 6. 完成： 汽缸（来自百度图片） appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equa