Photoshp设计一个质感的叹号标志.docVIP

Photoshop设计一个质感的叹号标志 1、新建文档1280x1024像素，背景填充浅灰色，建新层，画一个黑色椭圆，ctrl+T水平方向压扁一下，旋转一定角度。 2、添加图层样式。 效果如下。 3、建新层，用钢笔做如下选区，填充白色，不透明度35%。 4、建新层，方法同第一步，画一个白色椭圆。 5、添加图层样式。 效果如下。 6、建新层，同样的方法画一个黑色椭圆。 7、添加图层样式。 效果如下。 8、建新层，画一个白色椭圆，将椭圆选区调出，往右侧挪一段距离。 9、反选删除，去掉选区，高斯模糊3像素，图层不透明度30%。 10、建新层，画一个白色椭圆。 11、添加蒙版，用黑色柔角笔刷涂抹，类似下图效果。 12、建新层，用钢笔画出感叹号形状，填充#d1a3a4。 13、复制一层，颜色改为黑色，高斯模糊2像素左右。左下方向挪一段距离，图层模式改为叠加。再复制一层，颜色改为白色，添加一个浮雕样式，总体效果如下。 14、同样方法作出感叹号的圆点立体效果。 15、底部建新层，用钢笔做如下月牙选区，填充黑色。 16、添加图层样式。 效果如下。 17、建新层，用钢笔做如下月牙选区，填充白色，图层不透明度10%左右。 18、同样方法作出其它高光，下面制作倒影。合并所有符合层，复制一个，ctrl+T垂直翻转挪到底部，添加蒙版黑白直线渐变，效果如下。 19、建新层，添加一些阴影，最终效果如下。 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round t