白色有机电激发光元件之研究.docVIP

白色有機電激發光元件之研究The Study of White Organic Electroluminescent Devices 研究生：楊森宇 Sen-Yu Yang陳念慈 Nyen-Ts Chen由於生產與成本問題的考量下，近來白色有機電激發光元件 White Organic Light Emitting Devices, WOLEDs 結合彩色濾光片 Color Filter, CF ，已經成為製作全彩化OLED顯示器的主要方法之一。本論文將就有機電激發光元件中，黃色螢光染料Rubrene分別摻雜於電洞傳輸層 Hole Transparenting Layer, HTL 與電洞阻擋層 Hole Blocking Layer, HBL 中的發光情形作探討。在實驗中，首先將Rubrene摻雜於電洞傳輸層 NPB ，並藉由不完全的能量轉移來達到混光的效果。在Rubrene的摻雜濃度為2.5 wt.%時，得到最佳的互補白光OLED元件，CIEx,y色度座標為 0.34, 0.35 。其元件在電壓為16 V時，得到最高發光亮度為10725 cd/m2。在電流密度為30 mA/cm2時，得到最高發光效率為5.31 cd/A。接著，我們將Rubrene摻雜於電洞阻擋層 BCP ，在Rubrene的摻雜濃度為1.5 wt.%時，得到最佳的互補白光OLED元件，CIEx,y色度座標為 0.31, 0.32 。其元件在電壓為17 V時，得到最高發光亮度為8960 cd/m2。在電流密度為30 mA/cm2時，得到最高發光效率為4.77 cd/A。關鍵字︰白色有機電激發光元件、電洞阻擋層、摻雜、能量轉移。In consideration of fabrication and cost issue, Lately white organic light emitting Devices WOLEDs combined with Color Filter CF has become one of promising methods to produce full-color OLED displays. Rubrene is a yellow fluorescent dye. In our investigation, we would discuss obviously the emission behavior of organic electroluminescent devices by doping Rubrene into hole transport layer HTL and hole blocking layer HBL , respectively. In the experiment, we first doped Rubrene into hole transport layer NPB , and could obtain mixing-light effect by incomplete energy transfer. we obtain a optimum complementary white OLED as the doping degree of Rubrene is about 2.5 wt.%. The CIE coordinates located at 0.34, 0.35 . A maximum luminance of 10725 cd/m2 at 16 V and a luminance efficiency of 5.31 cd/A at 30 mA/cm2 were obtained in the device. After that, we doped Rubrene into hole-blocking layer NPB , and obtain a optimum complementary white OLED as the doping degree of Rubrene is about 1.5 wt.%. The CIE coordinates located at 0.31, 0.32 . A maximum luminance of 8960 cd/m2 at 17 V and a luminance efficiency of 4.77 cd/A at 30 mA/cm2 were obtained in the device. Keywords: WOLEDs, hole blocking layer, doping, energy transfer.