HP各种机型面信息汇总.docVIP

HP各种机型信息汇总 打印机不能读或写至少一次打印记忆或者至少有个记忆是。未经授权使用HP的。要继续按√。第一个的打印工作将被取消。未啮合接触高压或控制。啮合X 某纸盒卡纸 For help press or 13.03.00 Paper JAM open input trays then open and close top cover 卡纸时拉出纸盒，打开顶盖，然后再关闭顶盖 A page is jammed in tray X. 某纸盒有卡纸 A 13.01.00 error message indicates that the media did not arrive at the pre-feed sensor (PS102) within the specified time. A 13.01.00 报错信息表明在指定的时间内，纸张没有到达进纸传感器 A 13.03.00 error message indicates that the media did not arrive at the top-ofsensor (PS103) within the specified time. A 13.03.00报错信息表明在指定的时间内，纸张没有到达出纸传感器 NOTE: The 13.01.00 error can also be caused by the failure of the paperlevel sensor (PS107). If this sensor fails, the lifter motor does not rotate to lift the paper tray plate. 纸张水平传感器（PS107）） Turn the printer off and then on. Press Stop to clear all print jobs from the printer memory. Turn the printer off and then on. Try printing a job using a different software program. If the job prints, try using the original software program to print a different job.NOTE If the error message only appears when using certain software programs, contact the software program vendor for assistance. If the message persists with different software programs and print jobs, disconnect all of the cables and turn the printer off. If the error persists, perform a firmware upgrade. Remove all DIMMs, EIO devices, and CompactFlash solutions. Remove all EIO devices. Turn the printer on. If the error does not persist, reinstall the DIMMs, EIO devices, and CompactFlash one at a time.NOTE You must turn the printer off and then on when reinstalling each component. Replace the DIMM, EIO device, or CompactFlash if necessary. Reconnect all of the cables. 49.3046 打印A3幅面的图片，超过2张时，显示该错误代码。（HP5550） 内存不够，添加内存可以解决。 50.* FUSER ERROR 加熱組件錯誤,其*值表示如下:1 加熱溫度偏低2 加熱組件預熱保護3 加熱溫度偏高4 電源電壓不穩5 加熱組件不匹配 8 加熱溫度偏低 （低于最低限度） 9 加熱溫度偏高 （低于最低限度） 關掉電源,20分鐘后再開機; 重新安裝加熱組件; 關掉電源,取出加熱組件,檢查J1307-1和J1307-2以及J1308-1和J1308-2是否相通,如不通,更換另熱組件 51.1Y A laser beam error has occurred. Y Descript