成型工艺流程及件介绍.docVIP

成型工艺流程及条件介绍 （时间:2008-1-15 15:46:42 共有 617人次浏览） 成型工艺流程及条件介绍????Molding technique procedure and parameter introduction????第一節 成型工艺????Section 1 molding technique.????1.成型工艺参数类型????Sorts of molding parameter.????(1).注塑参数????ction parameter.????a.注射量????ction rate.????b.计量行程????Screw back position????c.余料量????Cushion????d.防诞量????Sucking back rate????e.螺杆转速????Screw speed????f.塑化量????Plastic0 rate????g.预塑背压????Screw back pressure????h.注射压力和保压压力????ction pressure and holding pressure????i.注射速度????ction speed????(2)合模参数????Clamping parameter????a.合模力????Clamping force????b.合模速度????Clamping speed????c.合模行程.????Clamping stroke????d.开模力????Opening force????e.开模速度????Opening speed????f.开模行程????Opening position????g.顶出压力????Ejector advance pressure????h.顶出速度????Ejector advance speed????i.顶出行程????Ejector advance position????2.温控参数????Temperature parameter????a.烘料温度????Dry resin material temperatureb.料向与喷嘴温度????Cylinder temperature and nozzle temperature????c.模具温度????Mold temperature????d.油温????Oil temperature????3.成型周期????Molding cycle????a.循环周期????Cycle time????b.冷却时间????Cool time????c.注射时间????ction time????d.保压时间????Holding pressure time????e.塑化时间????Plant time????f.顶出及停留时间????Knocking out and delay time????g.低压保护时间????Mold protect time????成型工艺参数的设定须根据产品的不同设置.????Molding technique parameter setting differs depending on type of product第二节成型条件设定????Section 2 Molding parameter Setting????按成型步骤:可分为开锁模,加热,射出,顶出四个过程.????Molding steps: mold opening/closing, heating ction and knocking out.????开锁模条件:????Mold opening parameter:????快速段中速度????低压高压速度????High-speedmid-speed????Low pressure high pressure speed????锁模条件设定:????Mold closing parameter setting????1锁模一般分:快速→中速→低压→高压????Mold closing: high-speed →low-speed →low pressure→high pressure????2.快锁模一般按模具情况分,如果是平面二板模具,快速锁模段可用较快速度,甚至于用到特快,当用到一般快速时,速度设到55-75%,完全平面