10分钟教你如对付指纹打卡机.docVIP

如何对付指纹打卡机通拥堵，上班又迟到； 手指脱皮，考勤又不认； 朋友聚会，想提前下班； 冬天想睡个懒觉......指纹考勤，让这一切均记录在案！上班真是烦！烦！烦！ 指纹打卡机就无法代打了吗？答案是否定的，一样可以搞定它！ 从今天开始，您不用再为此烦恼。 需要物品 * 透明胶带（比较宽的那种）* 双面胶* 蜡烛* 剪刀* 易拉罐* 打火机? ? 制作步骤 ? ?? ?1. 把易拉罐剪成如上图，所示形状，多剪两个备用。? ? ? 2. 把铝片熏黑，注意不是烧，是熏黑。 ? ? ?3. 熏成上面这样子，就可以了。? ? ? 4. 把手指头均匀的按到上面，注意，凉了以后按，小心烫到你手。? ? ? 5. 透明胶带上场，把手指上的黑色反粘到胶带上！? ? ? 6. 再找一个空白的易拉罐，把粘有指纹的胶带反粘到上面。? ? ? 7. 粘好了。? ? ? 8. 再剪小点。? ? 9. 背部站上双面胶。 ? ? 10. 哈哈，隐蔽性强啊。多做几个，给同事每人发一个。 ? 呵呵。警告，切勿用于非法用途，切勿给老板知道。嘻嘻～ stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil collide; genera