GHOST软件复工控机系统流程.docVIP

GHOST软件恢复工控机系统流程 打开GHOST软件，选择第一项LOCAL，如图在选择第一项DISK 此时选择第三项FROM IMAGE 双击需要恢复的GHOST镜像文件图中第一项为自己电脑的硬盘，第二项为需要安装的磁盘，本系统中使用的是16G的CF卡选择第二项，然后点击OK继续点击OK选择YES开始恢复文件 如图恢复完成后点击CONTINUE返回 然后选择QUIT退出软件 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil collide; generator stator Reed end set two people guardianship, guardianship generator rotor not and stator core coil collide friction. Slow journey to move into the direction of the rotor, rotor wear them into the stator bore, will contact steam-side slider on the arc skateboards (must be over ladder after the