网页设计与制作——框架结构.docVIP

实验七 框架结构 【实验：实验： 1frameset rows=* cols=200,300,* 2）分别在“框架”面板中选择相应的框架，插入相应的网页 III 框架网页中的超级链接 要求：1）创建左侧框架网页 2）在左侧框架中设定三个超级链接，并链接对应的网页文件。网页将在MainFrame显示。默认显示“2004年经典对白” 3）左侧框架背景为灰色 4）框架集需要显示边框，宽度为3象素 Ⅳ 利用已有网页制作框架网页 要求：按照样张所示，利用index文件夹中提供的四个网页，组成如图所示的框架网页 【参考习题】 创建一个顶部框架，TopFrame中显示新浪的首页，MainFrame显示163的首页。两个框架需要显示滚动条，显示框架边框。效果如下图 利用素材中的163、sina的图片制作如下的框架网页。 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil collide; generator stator Reed end set two people guardianship, guardianship generator rotor not and stator core coil colli