IICL国际验箱师新版题集.docx

1. Which of the following defects requires repair? (A) A loose door gasket (B) A bent J-bar that does not affect door operation (C) A dent 13mm (1/2 in) deep on door sill (D) Four dents, each 11 mm (7/16 in) deep, on contiguous outboard corrugations of a roof panel 2. Of the following conditions in a dry-van container, which one would require cleaning? (A) Raised mud foot prints in excess of what might normally remain after a sweep out (B) Dry dust covering dried floor stains as might normally be found after a sweep out (C) Coffee beans remaining inside the container as might occur after a sweep out (D) Polyurethane beads as might be expected to lodge in grooves between floorboards after a sweep out 3. An Equipment Interchange Receipt (EIR), based on an inspection with no damage found, can be evidence of a container’s compliance with: (A) Australian Timber Component Treatment Regulations (B) Convention for Safe Containers (CSC) regulations through the ACEP Program (C) Transport under custom’s seal (TIR) regulations (D) International Standards Organization (ISO) CEDEX codes regulations 4. The top of a replacement plastic ventilator should be centered what distance from the top side rail? (A) 50 – 55 mm (2 - 2-3/16 in) (B) 70 – 75 mm (2-5/8 – 3 in) (C) 100 mm (4 in) (D) 150 mm (6 in) 5. When must a reference line extend the full length of a bottom side rail? (A) When there are two or more areas of damage on the bottom side rail (B) When there is a sharp bend in the bottom side rail (C) When there is a bowing over the entire bottom side rail (D) When there is additional damage to the bottom side rail so that the reference line cannot be positioned over the ends of the damage 6. Which of the following profiles of corner post inserts would be considered an acceptable repair? 7. Which of the following is NOT a transverse structural member of the container? (A) Front sill (B) Tunnel rail (C) Rear header (D) Crossmember 8. A steel corner fitting is being replaced. To ensure