学光冷加工—本科毕业论文（设计）.docVIP

河南工业职业技术学院 Henan Polytechnic Institute 毕 业 设 计 题目 光学零件铣磨 系别 光电工程系 专业 精密机械技术　　　　 　　　　　　　　 班级 精 密 0901 姓名 田 俊 学号 150090106 指导教师 黄 长 春 日期 2011年10月10 摘要 铣磨机的使用大大提高了粗磨整平工艺的机械化程度。但由于机床本身的精度以及磨轮、磨削量、进给量、冷却液等多方面因素的影响,粗磨光学零件之光洁度一般只能达到220~#～240~#砂面。国内粗磨平面一般采用的磨轮粒度均在JR60~#～100~#之间,其浓度为100%。粗磨完工所要求的零件表面光洁度等级一般为6。从我国粗磨平面的特点来看,一般要去除较大的加工余量,单面余量多在2～3毫米之间,有的零件磨削第一面时其余量竟达5毫米以上。这势必要求金刚石磨轮具有良好的磨削性能,也就是磨轮应选用青铜结合剂且粒度应较粗。实践证明,粒度在80~#～100~#的磨轮由于其磨削力小,用于PM5 关键词：?光学零件?铣磨机?表面光洁度等级?线速度?真空吸盘?整平工艺?调速机构?粗磨?金刚石磨轮?粒度? Milling mill use has greatly increased the degree of mechanization of kibble leveling process. However, due to the accuracy of the machine itself, as well as grinding wheels, grinding amount, feed rate, coolant, and many other factors affect the roughing the optical parts of finish is generally only reach 220 to # 240 to # sand surface. Domestic kibble plane generally use the granularity of the grinding wheel between the JR60 ~ # ~ 100 ~ #, the concentration of 100%. Kibble completion requirements of the parts surface finish level generally ▽ 6. View from the our kibble plane features, generally to remove a larger allowance, single-sided margin of more than 2 to 3 mm, and some parts grinding the first side when the rest of the amount as high as more than 5 mm . This will require that the diamond grinding wheel with a good grinding performance, is the grinding wheel should be used bronze binder and coarse granularity should. Practice has proved that the particle size in the 80 ~ # 100 to # of the grinding wheel due to its small grinding force for PM5 Keywords: optical, parts milling, mill surface finish grade line, speed vacuum consolidation process, level governor