PROFACE机使用多国语言实现简繁体切换.docVIP

PROFACE人機使用多國語言實現簡繁體切換 打开需要实现的人机画面：选择工程-应用-转换文本列表。 2、选择否 3、在转换设置中将表1设置成中文（简体），表2设置成中文（繁体）‘选择转换。 4、选择-选择表。 5、只勾选表1和表2即可。 6、选择-语言切换。 7、将表1语言设定为-中文（简体），表2设定为-中文（繁体），在切换控制器地址设定PLC的对应地址，（以5127为例，当前设定D800）。 8、全选表2资料复制到WORD，在WORD中将资料转换成中文（简体），然后再将资料复制到表1中。 9、在5127为例，在密码设定页做以下功能开关，选择简体中文按键将D800置1，选择繁体中文按钮将D800置2。 以上即可完成将原繁体中文的人机画面实现一键切换简繁体功能。 equipment requirements, facilitate the introduction of cables and ducts. 6.2.9 outdoor cabinets, make appropriate rain cover. 6.3 for the Cabinet fixed the leg bolts should use the original Cabinet. 6.3.1 electrical distribution cabinets should be welded without special instructions, weld enclosure bottom corners, with base length in 20mm-40mm, welding should be solid, welding in the welding parts with preservatives. 6.3.2 electrical power equipment requirements, facilitate the introduction of cables and ducts. 6.2.9 outdoor cabinets, make appropriate rain cover. 6.3 for the Cabinet fixed the leg bolts should use the original Cabinet. 6.3.1 electrical distribution cabinets should be welded without special instructions, weld enclosure bottom corners, with base length in 20mm-40mm, welding should be solid, welding in the welding parts with preservatives. 6.3.2 electrical power equipment requirements, facilitate the introduction of cables and ducts. 6.2.9 outdoor cabinets, make appropriate rain cover. 6.3 for the Cabinet fixed the leg bolts should use the original Cabinet. 6.3.1 electrical distribution cabinets should be welded without special instructions, weld enclosure bottom corners, with base length in 20mm-40mm, welding should be solid, welding in the welding parts with preservatives. 6.3.2 electrical power