单相正弦波逆变电源设计论文（C语言编程、含pcb图）.doc

PAGE PAGE 42 单相正弦波逆变电源 摘要：本单相正弦波逆变电源的设计，以12V蓄电池作为输入，输出为36V、50Hz的标准正弦波交流电。该电源采用推挽升压和全桥逆变两级变换，在控制电路上，前级推挽升压电路采用SG3525芯片控制，闭环反馈；逆变部分采用驱动芯片IR2110进行全桥逆变，采用U3990F6完成SPWM的调制，后级输出采用电流互感器进行采样反馈，形成双重反馈环节，增加了电源的稳定性；在保护上，具有输出过载、短路保护、过流保护、空载保护等多重保护功能电路，增强了该电源的可靠性和安全性；输出交流电压通过AD637的真有效值转换后，再由STC89C52单片机的控制进行模数转换，最终将电压值显示到液晶12864上，形成了良好的人机界面。该电源很好的完成了各项指标，输入功率为46.9W，输出功率为43.6W，效率达到了93%，输出标准的50Hz正弦波。 关键词：单相正弦波逆变 DC-DC DC-AC SPWM Abstract: The single-phase sine wave inverter power supply design, battery as a 12V input and output for the 36V, 50Hz standard AC sine wave. The use of push-pull power booster and two full-bridge inverter transform，in the control circuit, the pre-boost push-pull circuit using SG3525 chip control, closed-loop feedback; inverter driver IC IR2110 in part to the use of full-bridge inverter using SPWM modulation U3990F6 completed, level after the use of current transformer output sampling feedback. The feedback link in the formation of a double and increase the stability of power. In protection, with output overload, short circuit protection, over current protection, the protection of multiple no-load protection circuit, which enhancing the reliability of the power supply and safety. AC voltage output of the AD637 True RMS through conversion, and then from the control of single-chip STC89C52 analog-digital conversion, the final value of the voltage to the liquid crystal display 12864 on the formation of a good man-machine interface. The completion of the power good indicators, input power to 46.9W, output power of 43.6W, the efficiency reached 93%, 50Hz sine wave output standards. Key words: Single-phase sine wave inverter DC-DC DC-AC SPWM 目录 1.系统设计 HYPERLINK \l _Toc114145364 4 1.1设计要求 HYPERLINK \l _Toc114145364 4 1.2总体设计方案 HYPERLINK \l _Toc114145364 4 1.2.1设计思路 HYPERLINK \l _Toc114145364 4 1.2.2方案论证与比较 HYPERLINK \l _Toc114145364 5 1.2.3系统组成 HYPERLINK \l _Toc114145364 8 2.主要单元硬件电路设计 HYPERLINK \l _Toc114145364 9 2.1 DC-DC变换器控制电路的设计 HYPERLINK \