TD-SCDMA系统信道编码技术研究毕业设计(论文).docVIP

本科毕业设计（论文）TD-SCDMA系统信道编码技术研究 院（系） 信息科学与工程学院 专 业 通信工程 届 别 2012 学 号 0815232021 姓 名 王喆 指导老师 彭盛亮 摘要 随着无线通信的发展，特别是在未来4G通信中，高速传输和高可靠性传输成为信息传输的两个主要方面。无线信道状况通常比较恶劣，信号不可避免会受到干扰而出错，所以可靠性尤其重要。为实现可靠性通信，常用的方法有两种：一种是增加发送信号的功率，提高接收端的信号噪声比；另一种是采用编码的方法对信道差错进行控制。前者常常受客观条件限制，不是所有场景都能采用。因此差错控制编码得到了广泛应用。 本文介绍了TD-SCDMA移动通信系统及其信道编码技术，着重介绍了卷积码的编码方法。论文搭建了通信系统模型，编写卷积码的编码程序，用MATLAB仿真软件对TD-SCDMA通信系统中2种不同码率（1/2码率与1/3码率）的卷积编码的纠错性能进行验证，并且对信源序列经过卷积编码、QPSK调制、AWGN信道、解调以及Viterbi解码后的误码率进行仿真和分析。 关键词：信道编码；TD-SCDMA；卷积码；误码率。 Research on Channel Coding Techniques for TD-SCDMA System Abstract With the development of wireless communication, especially in the future 4G communication, high-speed transmission and high-reliability transmission are both of vital importance for information transmission. Considering the bad condition of wireless channel, the signal inevitably suffers from inference and distortion, and thus reliability is extremely critical. There usually exist two ways to achieve reliable communication: One is to increase the transmitted signal power, which results in increase in the received signal to noise ratio; Another is the use of coding methods to eliminate the channel error. The former can not be adopted in all environments, thereby error control coding has been widely applied. This thesis describes the TD-SCDMA mobile communication system and its channel coding techniques, which highlights the convolutional code encoding method, sets up a communication system model, provides convolutional code encoding program, uses MATLAB simulation software to verify correction performance of the convolutional codes of different bit-rate (1/2 rate and 1/3 rate) in the TD-SCDMA communication system, and analyzes the BER of output sequences that have gone through the convolutional coding, QPSK modulation, AWGN channel, demodulation, and Viterb