毕业论文---生物技术公司科技研发楼框架结构土木工程.docVIP

江苏科技大学 本 科 毕 业 设 计 学 院 船舶与建筑工程学院 专 业 土 木 工 程 学生姓名 高 杨 班级学号 0945601212 指导教师 王素瑞、韦嶶 二零一三年六月Design Of Science and technology R D Building  摘 要 本工程为某生物技术公司科技研发楼，五层框架结构，首层层高3.9m,其他层层高为3.3m。总高度为18.0m。建筑总面积为4233.6m2。经过细致的方案论证，我们决定上部结构采用纵横向承重的钢筋混凝土框架结构。因为该工程抗震设防烈度为7度，所以不考虑竖向地震作用。在用底部剪力法求出水平地震作用后，利用D值法完成了水平地震作用下的一榀框架的内力组合计算。采用弯矩二次分配法分别完成了恒载和活载最不利布置作用下的内力计算。接着进行结构构件的地震作用效应与其它荷载效应的基本组合及无地震作用效应与其它荷载效应的基本组合两种情况，对框架内力进行组合，得出框架梁柱的控制内力，进而完成了梁柱截面的配筋计算。进行了独立基础的计算及零星构件的计算。用天正7.5、AutoCAD2007、PKPM2005软件等计算并绘制本工程建筑和结构施工图。 关键词: 地震；框架结构；二次分配法；荷载内力组合；截面设计；钢筋混凝土 Abstract This project is a building of Science and technology R D Building. This subject is a?five floor frame structure, the first layer of high 3.9m, other high-level 3.3m. The total height of 18.0m. The total building area of this project is4233.6m2.After complicated analysis, the frame structure of supporting weight in lengthways and transverse direction of reinforced concrete is adopted for the superstructure of this building.As the anti-earthquake degree is 7,vertical earthquake is skipped. After the horizontal earthquake is calculated by the bottom-shear method, the Value D method is applied to calculate the stress of a frame under horizontal earthquake. Then the stress under vertical dead load and the most adverse-arrange live load is calculated by the double-moment-divided method. Considering the two cases: the basic combination of the earthquake and the load and the basic combination of the load and no earthquake, the load effect combination is carried off. So according to the stress and of beams and columns, the section design is finished .The calculation of the independent foundation and other members are carried on. The software of