- 12
- 0
- 约3.13千字
- 约 14页
- 2016-11-27 发布于重庆
- 举报
正弦波三相變频电源的设计
PAGE
PAGE 1
三相正弦波变频电源的设计
摘 要
本设计分为:三相SPWM信号的生成、逆变回路及其驱动和输出的测量显示。选择电机控制专用DSP TMS320LF2407生成SPWM信号。逆变电路主回路采用智能功率模块(IPM)。输出测量采用电压电流传感器来实现电隔离。为加快速度,采用独立于DSP的PIC单片机实现输出的测量。
关键词: 变频;SPWM;DSP;PIC单片机
Abstract
The design is about tri-phase sinusoidal frequency conversion power.
Three parts are included: generating tri-phase SPWM signal, inverter circuit and its drive circuit, output measuring and display. DSP TMS320F2407 is used as the controller in the system. IPM is used in the Inverter main circuit. Voltage and current sensor is used in the measuring of output, it can insulate the control circ
原创力文档

文档评论(0)