與农药剂型相关的控制指标.docVIP

与农药剂型相关的控制项目 原药?technical material (TC) 母药 technical concentrate (TK) Declared content in g/kg or g/l at 20 ± 2°C Tolerance up to 25 ±15% of the declared content for “homogeneous” formulations (EC, SC ±25% for “heterogeneous” formulations (GR, WG, etc.) above 25 up to 100 ±10% of the declared content above 100 up to 250 ± 6% of the declared content above 250 up to 500 ± 5% of the declared content above 500? up to 900 ±25 g/kg or g/l above 900 up to 1000???the minimum content, only, is declared. Note In each range the upper limit is included 1.??????? 粉剂（DP） DUSTABLE POWDERS 1)水分含量 Water (MT 30.5) Maximum: ...... g/kg. 2）细度（通过75μm试验筛）Dry sieve test (MT 59.1) Maximum: 5% retained on a 75 μm test sieve. 3）酸碱度（以H2SO4或NaOH计）或pH范围 Acidity and/or Alkalinity (MT 191) or pH range (MT 75.3) Maximum acidity: ...... g/kg calculated as H2SO4.Maximum alkalinity: ...... g/kg calculated as NaOH.pH range: ...... to ...... 4）其他 Stability at elevated temperature (MT 46.3) 2.??????? 乳油(EC) Emulsifiable concentrates 1）水分含量Water (MT 30.5) Maximum: ...... g/kg. 2）酸碱度（以H2SO4或NaOH计）或pH范围 Acidity and/or Alkalinity (MT 191) or pH range (MT 75.3)?Maximum acidity: ...... g/kg calculated as H2SO4.Maximum alkalinity: ...... g/kg calculated as NaOH.pH range: ...... to ...... 3）乳液稳定性? Emulsion stability and re-emulsification (MT 36.1.1, MT 36.3 or MT 183) Time after dilution Limits of stability, MT 36.1, MT 36.3 0 h Initial emulsification complete 0.5 h Cream, maximum: ...... ml 2.0 h Cream, maximum: ...... ml Free oil, maximum: ...... ml 24 h Re-emulsification complete 24.5 h Cream, maximum: ...... ml Free oil, maximum: ...... ml Note: in applying MT 36.1 or 36.3, tests after 24 h are required only where results at 2 h are in doubt Time after dilution Limits of stability, MT 183 2 min AC reading maximum ...... 7 to 32 min AC reading similar to above (no major increase, decline or fluctuation) Note: in applying MT 183, initial AC reading will be 1 in most cases 4）其他 Persistent foam (MT 47.2)