CJ2M+CJW-SCU41-V1模块做Modbus-RTU从站.docVIP

CJ2M+CJ1W-SCU41-V1模块做Modbus-RTU从站 实验时间：2011年11月8号 实验人员：汪强 实验设备：CJ2M-CPU33,CJ1W-SCU41-V1,Commix 实验目的：CJ1W-SCU41-V1做modbus-rtu slave 实验步骤： 系统概述，硬件搭建和接线 ①CJ2M-CPU33加CJ1W-SCU41-V1，SCU模块安装在CPU右侧，盖上端板，用XW2Z-200S-CV连接SCU模块上的PORT2和电脑的串口。 ②modbus-rtu协议规则如下图： CJ2M单元设置 CPU先用USB和编程软件在线 双击IO表和单元设置 先把PLC切换到编程模式，然后点击IO表中的选项菜单，找到创建，然后点击确定，PLC自己创建IO表。双击CJ1W-SCU41-V1，出现如下图的设置，在显示的参数组中选到PORT2 SETTINGS。 在显示的参数组中选择PORT2 MODBUS-RTU SLAVE SETTINGS，把从站地址改为1。 这里如果从站地址默认0，SCU模块会报错。 3、COMMIX设置 波特率和数据格式需要与SCU模块一致 编程说明： Modbus-RTU从站的命令帧格式： 功能码如下： 01：读取位状态 02：读取CIO区多位状态 03/04：读取保持/输入寄存器内容 05/0F：写单个/多个位 06/10：写单个/多个寄存器 08：回路测试 实验现象： 01：读取位状态 读取CIO 0中0-9位的状态，共计10个位。 绿色为命令帧，蓝色为反馈帧 4个位地址是一个数字 01 01 00 00 00 10 3D C6 03/04：读取保持/输入寄存器内容 读取DM2000-2005中的值 01 03 07 D0 00 06 C5 45 读取CIO中100-105中的值 0F：写单个/多个位 把200.00-200.09置1 10：写单个/多个寄存器 分别往D100-D108写入0-8 scope this document applies to all branches of the Banks personal loans (not including personal loans and fund loans). 2.2 target customers, consumer loan customers: with a focus on marketing the Government civil servants, official staff of public institutions, telecommunications, electricity, tobacco and other more efficient State-owned enterprises staff, finance, insurance, education, scientific research scope this document applies to all branches of the Banks personal loans (not including personal loans and fund loans). 2.2 target customers, consumer loan customers: with a focus on marketing the Government civil servants, official staff of public institutions, telecommunications, electricity, tobacco and other more efficient State-owned enterprises staff, finance, insurance, education, scientific research scope this document applies to all branches of the Banks personal loans (not including personal loans and fund loans). 2.2 target customers, consumer loan customers: with a focus on marketing the Government civil servants, official staff of public institutions, telecommunicatio