DS8100電池组更换手册(Batterymoduleset).docxVIP

Service Information Center Models 921, 931, 922, 932, 9A2, 9B2 Release 4.3.6Exchange the battery module setUse approved?ESD procedures?to prevent damage.Attention:This is not a stand-alone procedure. Customer disruption and damage to the hardware might occur if microcode and power boundaries are not in the proper conditions for this service action.If you were sent here by a serviceable event FRU repair, the microcode and power boundaries have already been set.If you were not sent here by a serviceable event FRU repair, see?MAP1230 Replace a FRU without using a serviceable event.Notes:All the cables and FRUs to be removed must be uniquely identified so they can be reinstalled correctly.If an installed?earthquake resistance kit?prevents you from accessing this FRU, refer to?MAP1600.The battery module set contains three battery modules. Each battery module does not exceed the weight to be replaced by a single service provider.?All three battery modules must be replaced as a set.You are using this procedure to exchange a battery FRU (battery module set or battery module enclosure). Unless specifically directed by a MAP or next level of support, you must actually replace the FRU with a new FRU. Performing a pseudo-repair with an out-of-date or defective FRU, or closing a serviceable event without exchanging the FRU, can result in data loss.Parent topic:?Rack power and coolingRelated tasks:How to launch the service information centerRemove the battery module setThe old battery modules being replaced must be returned in the same packing material and strapped to the pallet that the new modules arrived on.To locate this FRU, do one of the following and then return here and continue to replace the FRU:If this FRU has a FRU identify indicator, use the FRU identify indicator, which is listed in?MAP1240 Locating FRUs using identify indicators.If not, use the location code.Note:?There might be cases where the FRU failure or fencing conditions prevent the FRU LED indicator from be