大学毕业设计—基于单片机的智能充电器设计.docVIP

目 录 摘要 1 关键词 1 Abstract 1 Key Words 1 引言 2 1 课题研究与设计指导思想 2 1.1 课题研究背景 2 1.2 设计指导思想 2 1.3 智能化的功能设计要求 2 2 主要元器件介绍及选用 2 2.1 单片机的介绍及选用 2 2.2 模数转换器 CS5522芯片 6 2.3 温度传感器PT100 7 3 几种常见电池介绍及基本参数特性 8 3.1 几种常见电池 8 3.2 锂离子电池基本参数特性 8 3.3 锂离子电池的优缺点 9 4 硬件电路的设计 10 4.1 硬件电路的总体设计思路 10 4.2 电源电路部分 10 4.3 测温电路部分 10 4.4 模数转换部分 12 4.5 充电指示部分 12 4.6 充电控制电路 12 4.7 单片机控制部分 12 5 软件设计 14 5.1 程序流程图 14 5.2 单片机的主要控制程序 14 6 软件仿真与调试 15 6.1 电源仿真 15 6.2 充电器两端的电压显示部分 15 7 总结 16 参考文献 17 附录 18 致谢 22  基于单片机的智能充电器设计 自动化专业学生 XXX 指导师介绍了的硬件组成，包采电路、控制电路，并对充电器的核心件单片机进行了。阐述的软件设计，对软件进行需求分析，实现系统的可靠性、稳定性、安全性和经济性。以语言为工具，进行了详细设计和编码实现 Intellgent Battery Charger Design Based on Single-chip Computer Student majoring in automation XXX Tutor XXX Abstract: Electronic technologys fast development causes various electronic products develops toward portable and the small lightweight direction, it also causes the more electrification products to use based on batterys power supply system. To resolve the battery charging problem , designed a AT89S52 microcontroller core universal smart charger, describes working principle, design of intelligent charger features some modes of charging ,and discussed in detail the system of hardware and software implementation. As a result of the high-performance micro-controller and high resolution A/D conversion circuit, ensure that the charger has a very high precision. In the basic parameters characteristics of battery is introduced on the basis of, also introduces the design of hardware system, including data acquisition circuit, control circuit, man-machine interface and microprocessor controller and power part, and the core components of the charger AT89S52 single chip microcomputer was introduced in full. Focus on include the charger software function design, the software control system not only has carried on the demand analysis, must also be charging control system reliability, stability, security and