the dying temperature is slowly rising.docVIP

the drying temperature is slowly rising, average hourly temperature rise control in 5 to 8 degrees. (3) to strictly control the temperature in the drying, make it within the prescribed scope, dry the highest temperature should be determined according to the grades of insulating materials, general core and winding of the highest temperature should be controlled in 70 to 70 degrees Celsius. (4) drying temperature is measured with a mercury thermometer is not allowed when using alcohol thermometer, resistance thermometer or temperature thermocouple. (5) to measure and record regularly winding insulation resistance, winding temperature, environment temperature, dry power supply voltage and current. Determination must disconnect the power supply, lest produce risk. (6) when the motor insulation resistance meet the specification requirements, at the same temperature stable after 5 hours, just think dry finish Second, the motor installed (a) motor installation requirements 1. The motor assembly in place, in order to prevent vibration, when installation should be between motor and the base liner hard a hard layer of wood or plastic and vibration control. 2. The four anchor bolt on all want to use spring washer, tighten the nut to tighten in a diagonal cross sequence, each as tight the nut to twist. 3. Wear a wire pole should be buried well before pouring concrete, connect the motor end of the steel pipe, pipe shall be not less than 100 mm from the ground, and should make it as far as possible close to the motor terminal box. 4. The level of motor correction in both horizontal and vertical. Available generally use level measurement, calibration of 0.55 mm thick pads under the pedestal of the steel, to adjust the levelness of the motor. 5. Steady loading motor gasket is generally not more than 3 pieces, gasket and foundation surface contact should be tight, motor base after the installation of secondary grouting. (2) transmission device installation calibration T