Multisi软件介绍.docVIP

Introduction to the NI Electronics Education Platform NI Electronics Education Platform软件介绍 Hands-On Session 手把手学习课程 Introduction 介绍 Overview 纵览This course is designed to give you a brief one-hour introduction to National Instruments Multisim software. The course focuses on the basic elements of schematic capture as well as simulation. Through four exercises, you can work with the NI Multisim environment, place and wire schematic components, simulate a completed circuit, and prototype and measure the resulting design. 本课程是用来对NI公司的Multisim软件做以简单的一小时介绍。课程集中介绍了电路图输入和仿真的基本部分。通过四个练习，你可以在NI公司的Multisim环境下工作，为电路元器件布局布线，对整个电路进行仿真，然后对最终的设计进行原型化和测量。Design Challenge 设计挑战The exercises in this course are presented in the form of a design challenge. Each of the exercises is a step of the engineering design process. The challenge is to design a bandpass filter using the 741 operational amplifier. 本课程中的练习是以设计挑战的形式给出的。每个练习都是工程设计流程中的一个步骤。 挑战：采用741运算放大器来设计一个带通滤波器。Using Multisim, capture the filter and investigate its characteristics through simulation including gain and bandwidth. Then prototype the circuit in a 3D breadboarding environment. If you have the National Instruments Educational Laboratory Virtual Instrumentation Suite (NI ELVIS) workstation, you can prototype this circuit in the lab and measure its characteristics. Finally, during the last stage of the process, compare the real life behavior of the circuit with the simulations created in Multisim. REF _Ref159050410 \h \* MERGEFORMAT Figure 1 shows the design process by the corresponding exercise number. 采用Multisim输入滤波器的原理图并进行仿真，测量滤波器特性(包括增益和带宽)。然后将电路在三维面包板环境中进行原型化。如果你有NI公司的教学实验室虚拟仪器包(NI ELVIS)工作站，那么你可以将电路在这个实验室中进行原型化并测量其特性。最后，在设计流程的最后一步，将电路的实际性能与使用Multisim得到的仿真结果进行比较。表1按照相应的实验序号显示了整个的设计过程。 Figure SEQ Figure \* ARABIC 1. Design Process 表1. 设计流程 Course Requirements 课程要求 NI Multisim 10.0NI ELVIS and the NI ELVIS 3.0 softw