毕业设计(论文)_ZH24001628TF型液压支架(托梁分体)设计.docVIP

河北工程大学毕业设计 PAGE PAGE II 摘 要 本次设计的题目是ZH2400/16/28TF型液压支架（托梁分体），我在本次设计中主要负责该支架主体部分的设计。此次任务包括顶梁、伸缩梁、托梁等主体的设计与强度计算。 这种支架的顶梁采用分体组合式结构。采用分体式顶梁代替整体顶梁是因为该支架结构简单、重量轻、造价低、节省空间，大大减轻了支架的整体重量，前伸梁采用伸缩式的，支撑过程中能与煤壁接触，不仅起到一定的掩护作用，而且还能起到一定的支撑作用，使支架更稳定。该支架具有质量小，机动性能好，拆装运输方便等特点，适用于中小型煤矿或巷道断面狭小、无法正常布置工作面的边角煤回收区域采场支护。 关键词：液压支架；分体顶梁；托梁；边角煤 Abstract This design is entitled ZH2400/16/28TF Hydraulic stent (split joist), I in this design is mainly responsible for the design of the main part of the stent. The mandate includes roof beams, over cylinders, telescopic beams, joists and other body design and strength calculation. The top beam stent combined with split structure. Top beam instead of using separated because of the integrated roof beam bracket for simple structure, light weight, low cost, save space, greatly reducing the overall weight of the stent, using telescopic beam, the support process to contact with the floor, not only from to cover a certain role, but also play a supporting role, so stand more stable. The stent has the quality of small, good mobility, accessibility and other transport characteristics of anti-cheat for small medium and small coal mines, or roadway section, not the normal layout of recovery of the regional boundary coal face stope support Key words: hydraulic support; fission top-beam; joist;corner coal  目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295477175 摘 要 PAGEREF _Toc295477175 \h I HYPERLINK \l _Toc295477176 Abstract PAGEREF _Toc295477176 \h II HYPERLINK \l _Toc295477177 绪 论 PAGEREF _Toc295477177 \h 1 HYPERLINK \l _Toc295477178 1.1 液压支架的发展 PAGEREF _Toc295477178 \h 1 HYPERLINK \l _Toc295477179 1.1.1国外液压支架的发展状况 PAGEREF _Toc295477179 \h 2 HYPERLINK \l _Toc295477180 1.1.2国内液压支架研究情况 PAGEREF _Toc295477180 \h 2 HYPERLINK \l _Toc295477181 1.2 我国液压支架研究与应用中存在的问题 PAGEREF _Toc295477181 \h 3 HYPERLINK \l _Toc295477182 1.3 液压支架的组成 PAGEREF _Toc295477182 \h 4 HYPERLINK \l _Toc295477183 1.4支架的支护方式 PAGEREF _Toc295477183 \h 4 HYPERLINK \l _