本科毕设论文---数字信号在电源供电线路上的载波传输电路设计.docVIP

毕业设计论文 数字信号在电源供电线路上的载波传输电路设计 摘要 电力线路本身是用来传输电能的，因而在现代社会里它随处可见，是一笔巨大的财富。随着通信技术的不断发展，电力线通信技术日益引起人们的关注。DIGITAL SIGNAL IN THE POWER SUPPLY LINE CARRIER TRANSMISSION CIRCUIT ABSTRACT Power line itself is used to transmit electrical energy, which can be seen evetywhere in the modern society is a great asset. With the continuous development of communication technology, power line communications technology is of growing concern.Power Line Communication (PowerLine carrier communition) technology makes the power line as a communication medium of communication. This method can avoid the construction of new communications networks and investment, and thus it has great convenience, maintenance-free and plug and play features, the PLC has been widely applied. Power Line unfavorable factors for the transmission of information is the line impedance, signal attenuation and noise . Therefore, Software design, device selection and power line interface design is the key in the system development.This paper describes the hardware circuit design of a FSK power line carrier communication system which formed by a power line carrier chip ST7536 microcontroller and a downloadable ST12C5A60S2 SCM.This paper emphatically demonstrates the system and each unit circuit implementations , it makes the ST7536 MCU as the core of the core system which includes the reset, crystal oscillator circuit, transceiver circuit and interface circuit.It also introduces the system microcontroller which based on STC12C5A60S2 programming circuit design includes a MAX232 SCM-PC computer interface circuit, reset, crystal oscillator circuit and interface circuit. At the same time using a simple microcontroller programming software keil writes the controller program, and debugs simple steps to achieve results and error analysis. The communication system uses the existing low-voltage power grid as a channel FSK-based narrowband power line carrier communication method for data transfer and information exchange.