freshwater genetor.docVIP

Fresh water generator 1 Description of the plant and its system 1.1 Working description with engine jacket cooling water heating The DongHwa Entec fresh water generator uses the heat from Main Engine Jacket Cooling Water to produce drinkable water by evaporating sea water due to the high vacuum, which enables the feed water to evaporate at below 45℃. Steam can also be used as heat source instead of hot jacket water.The DongHwa Entec fresh water generator is based on 2 sets of titanium plate Heat exchangers, acting as an evaporator and a condenser respectively. The water ejector enables evaporator chamber vacuum condition by driving sea water pass through water ejector, and sea water supplied by ejector pump to be delivered to ejector for taking out the brine and air. The feed water evaporates while entering to the evaporate chamber due to the vacuum condition. The water spray and droplets are partly removed from the vapor by the deflector mounted on top of the evaporator and partly by a build-in demister. The feed water evaporates while entering to the evaporate chamber due to the vacuum condition. The water spray and droplets are partly removed from the vapour by the deflector mounted on top of the evaporator and partly by a build-in demister. The separated water droplets fall back into the brine, which is extracted by the ejector pump. The desalted vapour, which passes through the demister, will be sucked into the plate condenser where it will be condensed by means of incoming cold sea water. The distilled water will be taken out by integral fresh water pump and controlled by salinometer and solenoid valve. If it is of high salt content, the solenoid valve recirculation work starts automatically to the shell or dumping line against high salt content. The salinometer(salinity indicator) is connected to remote alarm so that very high salinity is registered immediately at the bridge of the ship or the engine control room. Thermomete