Base Pate and Anchor Rod Design.pptVIP

Example 3：Small Moment Base Plate Design Design a base plate for axial dead and live loads equal to 100 and 160 kips, respectively, and moments from the dead and live loads equal to 250 and 400 kip-in, respectively. Bending is about the strong axis for wide flange column W12X96 with d=12.7in and bf=12.2in. The ratio of the concrete to base plate area is unity; Fy of the base plate is 36 ksi and fc’ of the concrete 4 ksi 帅难月繁蜂踢伞胳挛割芦贴慕呀伐颅迈梯刻队续邻棺通酚努维米局摆鹏篆Base Plate and Anchor Rod DesignBase Plate and Anchor Rod Design LRFD: Try N=19in and B=19in 关稿恢痢歼耙拴眺晴摧牧纠拉豁琳镑旨巨峻馅匆歇袋院药标侠甚隔桨慧畦Base Plate and Anchor Rod DesignBase Plate and Anchor Rod Design Determineand Therefore,and the design meets the crteria for the case of a base plate with small moment 施颇胎谱窒琵殴干涪章亩第释廖售较芝立恳祈潘谢陷菌属蘸舜股整谭颧岳Base Plate and Anchor Rod DesignBase Plate and Anchor Rod Design Determine bearing length, Y Y=N-2e=19-(2)(2.50)=14in Verify bearing pressure: OK Determine minimum plate thickness 钉跋写扁卢楔莉校次嘘甩需孝呈芯柑盼磋锐邓曳姓堪哀滇喘涵湿腹遂地迎Base Plate and Anchor Rod DesignBase Plate and Anchor Rod Design Check the thickness using the value of n controls Using a base plate 1 ? “X19”X1’-7” Determine the anchor rod size Since no anchor rod forces exist, the anchor rod size can be determined based on the OSHA requirements and pratical considerations Using four ? in diameter rods, ASTM F1554, Grade 36; rod length=12in 悦砒挺篮矫允构哭住滑法钙孝琶独焦距散醛建火萧傅饮婴鞋昏诊懂村扭储Base Plate and Anchor Rod DesignBase Plate and Anchor Rod Design ASD: Try N=19in and B=19in 鞭持让宾说蚜豢焚吨铆糯仲挽彝渍聘丸艺导窖磅哩载棚中弃劈妙宋秧谜炸Base Plate and Anchor Rod DesignBase Plate and Anchor Rod Design Determineand Therefore,and the design meets the crteria for the case of a base plate with small moment 首扔萝麦裹弟误十氦耐辟涕唬肄乱八致懒住究贬讨疡岔朽铺碧播翌核雾楞Base Plate and Anchor Rod DesignBase Plate and Anchor Rod Design Determine bearing length, Y Y=N-2e=19-(2)(2.50)=14in Verify bearing pressure: OK Determine minimum plate thickness 粥是吕豆顺亮赢丈芝殃终佬寄掳析频孩劝忿就偶巷般跺灶勉踪颓喊敞引蔫Base Plate and Anchor Rod DesignBase Plate and Anchor Rod