ARGOHTOS油箱滤器.docVIP

Return Filters E 443 ? E 453 ? E 463 E 643 ? Tank top mounting ? Nominal flow rate up to 680 l/min 20.50-6e Description  Application In the return line circuits of hydraulic systems. Performance features Protection against wear: By means of filter elements that, in full-flow filtration, meet even the highest demands regarding cleanliness classes. Protection against malfunction: By means of full-flow filtration in the system return, the pumps above all are protected from dirt particles remaining in the system after assembly, repairs, or which are generated by wear or enter the system from outside. Special features By-pass valve: The location close to the inlet port prevents dirt particles retained by the filter element from entering into the clear oil side. Removable bowl: In case of maintenance the filter bowl is removed together with the filter element - therefore dirt particles are not flushed back into the tank. Filter elements Flow direction from outside to centre. The star-shaped pleating of the filter material results in: ? LARGE fiLTER SURFACES ? LOW PRESSURE DROP ? HIGH DIRT-HOLDING CAPACITIES ? LONG SERVICE LIFE In filters with a magnetic system, the ferromagnetic particles in the fluid pass first through a strong magnetic field and are separated. Characteristics Nominal flow rate Up to 680 l/min (see Selection Chart, column 2) The nominal flow rates indicated by ARGO-HYTOS are based on the following features: · CLOSED BY-PASS VALVE AT ? ≤ 200 mm2/s · ELEMENT SERVICE LIFE 1.000 OPERATING HOURS AT AN AVERAGE fluid contamination of 0,07 g per l/min flow volume · flOW VELOCITY IN THE CONNECTION LINES ≤ 4,5 M/S Connection Threaded ports according to ISO 228 or DIN 13 and SAE-flange (3000 psi). Sizes see Selection Chart, column 6 (other port threads on request) Filter fineness 5 μm(c) ... 60 μm(c) ?-values according to ISO 16889 (see Selection Chart, column 4 and diagram