layou method.docVIP

layout method Ground secondary network layont: in head point with total station coordinate lofting method, layout the set point, and then take a closed ring junction station, and some other test for right Angle and distance. Measurement of the test results accord with the engineering article 7.2.4 Ⅰ grid accuracy level architecture. The Angle error is less than + 5 \, relative error is less than 1/30000 of length. After inspection, establish ground control piles on the extension cord. Control piles with large pile pouring concrete, hand and foot pipe maintenance. 6.1.2.3.1.3.3 foundation pad, and the stage of secondary network layout Methods of cushion and pile caps establish secondary network basically the same with the ground, in addition to the inspection of the closure, and audited with ground control pile pitch line. Cushion with chalk line mark, secondary branch floor secondary branches in slab concrete construction at each point on the embedded embedded parts 200 x 200 mm, correct closure on the built-in parts of naturalization, determine the end point, 2 mm holes with copper, act as a benchmark for upper secondary network to transfer. 6.1.2.3.1.3.4 main secondary network layout Main use of internal control method using laser vertical transmission, the lower part of the height by 2 kg pendant, apparatus and theodolite to pass up. When after the completion of the foundation construction, at the bottom of the foundation pit has been basically stable, above all when measuring for foundation pit outer axis, elevation control points of review, verify the control points, using a laser theodolite J2 - JDA, level DS3 will cast to zero elevation control points, axis layer board on the surface, and set up the building height control points and control axis control network system. Now formed independent system within the building, and external elevation, the axis control points into the structure of the deformation system, will serve as the building settlement, uneven s