《模具外文翻译-铝合金半固体压铸模具充型过程的测量方法和模拟》.docVIP

宁波大红鹰学院毕业设计（论文）外文翻译所在学院： 机械与电气工程学院班 级：姓 名：学 号：指导教师：合作导师：年 月 日Mensuration and simulation of mold filling process in Semi - solid die-cast of aluminum alloyAbstract To understand the flow trace of semi—solid slurry in mold cavity, some thermocouples were inserted in mold cavity, and the reaction timing of thermocouples showed the arrival of fluid．The filling time and rate were estimated by comparison between the experiment and calculation．The introduction of computer simulation technique based on ADSTEFAN was to predict injection．forming process and to prevent defects during trial manufacture of various parts．By comparing the formed apearance of parts in experiment and in simulation．and observing the relationship between inteal defects inspected by X—ray or microscope and the flow field obtained in simulation．it was indicated mat both have quite good aeement in simulation and experiment．Right predictions for cast defects resulted from mold filling can be carried out and proper direction was also proposed．The realization of numerical visualization for filling process during semi．solid die—cast process will play an important role in optimizing technology plan．Key words：mold filling；simulation；semi—solid process；A1 alloy. 1 Introduction Semi—solid die cast process with various features [1—6]is a forming technology developed on the base of general molten metal die cast，and has gradually become maturity as near-net—shape processing of material．Compared with traditional die cast，there are a lot of unsolved theoretical and technological problems in semi - solid die cast process．Especially, because mature data are absent from the design of gating system，design experiences for die cast of molten metal are temporarily used．To grasp filling process of semi—solid die cast，the filling trace of semi—solid molten metal in mold cavity needs to be measured for storing some basic data by experiments．To optimize this filling process，to aid the design of die cavity, to fo