《车辆工程毕业设计(论文)－JX1021TS3轻型货车驱动桥设计【全套图纸】》.doc

本科学生毕业设计 轻型货车驱动桥设计 院系名称： 汽车工程 专业班级： 车辆工程 学生姓名： 指导教师： 职 称： 讲 师  The Graduation Design for Bachelors Degree Design of Pickup Truck Driving Axle Candidate：Specialty：Vehicle　Engineering　 ClassB07-1 Supervisor：Lecturer. Heilongjiang Institute of Technology  摘 要 轻型汽车在商用汽车生产中占有很大的比重，而且驱动桥在整车中十分重要。驱动桥作为汽车四大总成之一，它的性能的好坏直接影响整车性能，而对于载货汽车显得尤为重要。为满足目前当前载货汽车的快速、高效率、高效益需要时，必须要搭配一个高效、可靠的驱动桥。设计出结构简单、工作可靠、造价低廉的驱动桥，能大大降低整车生产的总成本的轻型货车驱动桥具有一定的实际意义。本首先论述了驱动桥的总体结构，在分析驱动桥各部分结构型式、发展过程及其以往形式的优缺点的基础上，确定了总体设计方案：桥壳采用在本次设计中，主要完成了的设计桥壳工作。最后运用AUTOCAD完成装配图和主要零件图的绘制。 关键词：轻型货车驱动桥单级主减速器差速器半轴桥壳 A Pickup trucks take a large proportion of commercial vehicles production, and the drive axle is one of the most important structure. Drive axle is the one of automobile four important assemblies, Its performance directly influence on the entire automobile, especially for the truck .Because using the big power engine with the big driving torque satisfied the need of high speed, heavy-loaded, high efficiency, high benefit today` truck, must exploiting the high driven efficiency single reduction final drive axle is becoming the trucks’ developing tendency. Design a simple, reliable, low cost of the drive axle, can greatly reduce the total cost of vehicle production, so the title of the fine structure of the design of a pickup vehicle drive axle has a certain practical significance. The configuration of the Driving Axle is introduced in the thesis at first. On the basis of the analysis of the structure and the developing process of Driving Axle, the design adopted the Integral Driving Axle, Single Reduction Gear for Main Decelerator’s deceleration form, Spiral Bevel Gear for Main Decelerator’s gear, Full Floating for Axle and Casting Integral Axle Housing for Axle Housing. In the design, we accomplished the design for Double Reduction Gear, tapered Planetary Gear Differentia