Section 3 25 00 - HVAC WATER TREATMENT.docVIP

SECTION 23 25 00HVAC WATER TREATMENT SPEC WRITER NOTE: 1. Delete between //// if not applicable to project. Also delete any other item or paragraph not applicable in the section and renumber the paragraphs. 2. References to pressure in this section are gage pressure unless otherwise noted. PART 1  GENERAL 1.1 DESCRIPTION A. This section specifies cleaning and treatment of circulating HVAC water systems, including the following. 1. Cleaning compounds. 2. Chemical treatment for closed loop heat transfer systems. 3. Chemical treatment for open loop systems. 4. Glycolwater heat transfer systems. 1.2 RELATED WORK A. Test requirements and instructions on use of equipment/system: Section 01 00 00, GENERAL REQUIREMENTS. B. General mechanical requirements and items, which are common to more than one section of Division 23: Section 23 05 11, COMMON WORK RESULTS FOR HVAC and STEAM GENERATION. C. Piping and valves: Section 23 21 13, HYDRONIC PIPING and Section 23?22?13, STEAM and CONDENSATE HEATING PIPING. D. //Cooling Towers//Fluid Coolers//: Section 23 65 00, COOLING TOWERS. DESIGNER NOTE: The designer shall consult with local water treatment specialists to determine the appropriate water treatment strategy for the HVAC systems included in the project. 1.3 QUALITY ASSURANCE A. Refer to paragraph, QUALITY ASSURANCE in Section 23 05 11, COMMON WORK RESULTS FOR HVAC and STEAM GENERATION. SPEC WRITER NOTE: Evaluate the extent of technical services on a case by case basis. B. Technical Services: Provide the services of an experienced water treatment chemical engineer or technical representative to direct flushing, cleaning, pre-treatment, training, debugging, and acceptance testing operations; direct and perform chemical limit control during construction period and monitor systems for a period of 12 months after acceptance, including not less than 6 service calls and written status reports. Emergency calls are not included. //During this period perform