机械专业取术语.docVIP

主题：模具设计、加工专业述语 模具述语??一、入水：gate??进入位：　gate location??水口形式：gate type??大水口：edge gate??细水口： pin-point gate??水口大小：gate size??转水口：　switching runner/gate??唧嘴口径：　sprue diameter??二、流道: runner??热流道：hot runner,hot manifold??热嘴冷流道:hot sprue/cold runner??唧嘴直流: direct sprue gate??圆形流道：round(full/half runner??流道电脑分析：mold flow analysis??流道平衡:runner balance??热嘴：　hot sprue??热流道板：hot manifold??发热管：cartridge heater??探针: thermocouples??插头：　connector plug??插座： connector socket??密封/封料： seal??三、运水：water line??喉塞：line lpug??喉管：tube??塑胶管：plastic tube??快速接头：jiffy quick connector plug/socker??四、模具零件：　mold components??三板模：3-plate mold??二板模：2-plate mold??边钉/导边：leader pin/guide pin??边司/导套：bushing/guide bushing??中托司：shoulder guide bushing??中托边L：guide pin??顶针板：ejector retainner plate??托板：　support plate??螺丝： screw??管钉：dowel pin??开模槽：ply bar scot??内模管位：core/cavity inter-lock??顶针：　ejector pin??模具专业英语司筒：ejector sleeve??司筒针：ejector pin??推板：stripper plate??缩呵：movable core,return core core puller??扣机（尼龙拉勾）：nylon latch lock??斜顶：lifter??模胚（架）： mold base??上内模：cavity insert??下内模：core insert??行位（滑块）： slide??镶件：insert??压座/斜鸡：wedge??耐磨板/油板：wedge wear plate??压条：plate? ?撑头: support pillar??唧嘴： sprue bushing??挡板：stop plate??定位圈：locating ring??锁扣：latch??扣鸡：parting lock set??推杆：push bar??栓打螺丝：S.H.S.B??顶板：eracuretun??活动臂：lever arm??分流锥：spure sperader??水口司:bush??垃圾钉：stop pin??隔片：buffle??弹弓柱：spring rod??弹弓:die spring??中托司：ejector guide bush??中托边：ejector guide pin??镶针：pin??销子：dowel pin??波子弹弓：ball catch??喉塞: pipe plug??锁模块：lock plate??斜顶：angle from pin??斜顶杆：angle ejector rod??尼龙拉勾：parting locks??活动臂：lever arm??复位键、提前回杆：early return bar??气阀：valves??斜导边：angle pin??术语：terms??承压平面平衡：parting surface support balance??模排气：parting line venting??回针碰料位：return pin and cavity interference??模总高超出啤机规格：mold base shut hight??顶针碰运水：water line interferes withejector pin??料位出上/下模：part from cavith (core) side??模胚原身出料位：cavity direct cut on A-pl