大型烧结机头电除尘新型控制技术开发大型烧结机头电除尘新型控制技术开发.docVIP

烧结机头电除尘新型控制技术开发应用 (the Iron-making Plant of JIGANG GROUP CO., LTD) Abstract The head of the sinter machine is higher in dust rate, is thinner in grain and higher in conglutination. At the same time, it esistes that the phenomenon of the return fines at the head of the Sinter machine. Spark shadow control, spark energy rank control and peak value control are just provided with the traditional electronic dust abatement and the electric power control machine, which can’t immediately adjust to control the mode in the running of the electric field. So the traditional working not only brings us the misadventure effect of dust abatement but also costs a lot of electronic energy.Simultaneity. The name EPICIII electronic dust abatement system which belongs to ALSTOM company, is used to control the parameter of the running electric field and adopt the controller of vibrancy. The running of the electric field and the low-pressure control is connected by the Ethernet communication for achieving the function of computer monitor and operation. Its dedusting effection precedes the traditional the electric power controller of electronic dust abatement.Contemporary, it has the advantages of saving the electric power and operation simpleness. Key words Electronic dust abatement；EPICIII electronic dust abatement system；Gas transport system 前言 在烧结生产过程中产生的主要污染物是粉尘，粉尘治理以电除尘器为主要净化设备。电除尘器具有运行费用低、阻力小、处理烟气量大、除尘效率较高的特点。随着环保要求日益严格，污染排放实行总量控制及节能减排要求，寻求更优良的除尘效果是大势所趋。虽然加长、加高、加大电除尘器本体可以相应提高除尘效率，但受场地限制，且投资较大。这就要求必须寻求新的控制技术和设备，其中最主要、效果最为明显的是寻找更优良的电除尘控制器来达到提高电除尘器除尘效率的目的。通过广泛调研，与设备厂家技术交流，法国阿尔斯通的EPICⅢ控制器是目前较为理想的控制设施。 2．EPICⅢ控制器的先进性 EPICⅢ控制器利用集成在控制器内部的三个专用软件进行电场参数跟踪调节，其具体技术先进性如下： 2.1单一的供电分区 图1 传统控制方式图 图2 EPICⅢ控制器控制方式 通过图1、图2比较可以看出，每个EPICⅢ控制器对一个电场的各项参数进行控制。这样就避免了控制交叉，降低了整体电场实效的可能性。 2.2 EPOQ－排放优化 安装于每个EPICⅢ单元中的优化软件EPOQ，完全不依赖浊度信号，对电压KV和电流mA信号快速取样，调整二次电流及间歇供电比达到向供电分区提供最大可能的“有效充电”，从而使每台除尘器中的阳极板都处于最好的工作状态，使ESP的集尘效率最大化，充分降低除尘器的排放量。