stm32函数(3.5)集.docVIP

一、流水灯 (1)定义和初始化GPIO管脚 GPIO_InitTypeDef GPIO_InitStructure; GPIO_InitStructure.GPIO_Pin = GPIO_Pin_0; GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP; GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz; GPIO_Init(GPIOB, GPIO_InitStructure); //初始化 (2)库函数积累 RCC_APB2PeriphClockCmd( RCC_APB2Periph_GPIOB|RCC_APB2Periph_GPIOF, ENABLE);//开启时钟(RCC_APB1PeriphClockCmd() ） GPIO_SetBits(GPIOB, GPIO_Pin_0);//设置为1 GPIO_ResetBits(GPIOF, GPIO_Pin_7|GPIO_Pin_8);//设置为0 Leaning (a) 输入宏 #define LED1(a) if (a) \ GPIO_SetBits(GPIOB,GPIO_Pin_0);\ else \ GPIO_ResetBits(GPIOB,GPIO_Pin_0) (b) 叠层嵌套 #define digitalHi(p,i) {p-BSRR=i;} //设置为高电平 #define digitalLo(p,i) {p-BRR=i;} //输出低电平 #define digitalToggle(p,i) {p-ODR ^=i;} //输出反转状态 /* 定义控制IO的宏 */ #define LED1_TOGGLE digitalToggle(GPIOB,GPIO_Pin_0) #define LED1_OFF digitalHi(GPIOB,GPIO_Pin_0) #define LED1_ON digitalLo(GPIOB,GPIO_Pin_0) Polling 库函数积累 GPIO_WriteBit(GPIOC,GPIO_Pin_3,(BitAction)((1-GPIO_ReadOutputDataBit(GPIOC, GPIO_Pin_3)))); //取反或者写入设置某个io口的高低 GPIO_ReadInputDataBit(GPIOA,GPIO_Pin_3);//读取io口输入电平 GPIO_ReadOutputDataBit(GPIOA,GPIO_Pin_3);//读取io口输出电平 三、EXTI-按键 (1) 初始化中断 EXTI_InitTypeDef EXTI_InitStructure; GPIO_EXTILineConfig(GPIO_PortSourceGPIOA, GPIO_PinSource0); EXTI_InitStructure.EXTI_Line = EXTI_Line0; EXTI_InitStructure.EXTI_Mode = EXTI_Mode_Interrupt; EXTI_InitStructure.EXTI_Trigger = EXTI_Trigger_Falling; //下降沿中断 EXTI_InitStructure.EXTI_LineCmd = ENABLE; EXTI_Init(EXTI_InitStructure); /**************配置nvic和中断组********************/ NVIC_InitTypeDef NVIC_InitStructure /* Configure one bit for preemption priority */ NVIC_PriorityGroupConfig(NVIC_PriorityGroup_1);//选择组 /* 配置中断源 */ NVIC_InitStructure.NVIC_IRQChannel = EXTI0_IRQn; NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 0; NVIC_InitStructure.NVIC_IRQChannelSubPriority = 0; NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE; NVIC_Init(NVIC_InitStructure); (2) 库函数积累 EXTI_GetIT