U形管换热器水压试验大纲-法兰连接结构.docVIP

设备水压试验大纲 The Hydrostatic Test Brief 设备型号： Equipment Type： 编 制： Prepared by： 审 核： Reviewed by： 批 准： Approved by： 分发号： Distribution No.： 设备水压试验大纲 The Hydrostatic Test Brief 1概况 General 1.1项目名称： Project Name: 1.2设备名称： Equipment Name: 1.3设备型号： Equipment Type: 1.4设备试验参数：按相应型号的设备图样 Test Parameter: See the drawing 2 编制依据 Reference Standard: TSG R0004-2009《固定式压力容器安全技术监察规程》 《Supervision Regulation on Safety Technology for Stationary Pressure Vessel》 GB150-2011《压力容器》 GB150-2011 《Pressure vessel》 GB151-1999《管壳式换热器》、 GB151-1999《Tubular Heat-exchanger》 JB/T8190-1999 《高压加热器技术条件》 JB/T8190-1999《The Technology Condition of HP Heater》 NX/QP16-2006《压力试验质量控制程序》 NX/QP16-2006《The Quality Control Procedure of Pressure Test》 3 对受试产品试验前的要求 The requirement prior to test 3.1对受试产品应是在水压试验前规定的各项制造、检验检测工作均已圆满完成且合格。 The hydrostatic test shall be made after being fabricated, inspected and accepted. 3.2对带有补强圈的设备应在试验前对补强圈部位先通入0.4～0.5MPa的压缩空气进行泄漏检查。合格后方可进入下一步的试验工作。 To the equipment with reinforcement pad, It shall be full-fill of the 0.4～0.5MPa compressure air to the reinforcement location to make the leakage inspection prior to the whole test. The next test step will be in process after the above result is acceptable. 4试验准备 Test Preparation 4.1压力表的选用与安装 Selection and Installation of Pressure Gauge 应按图样规定的试验压力，配备两个量程相同并经校正过的压力表，其量程宜为试验压力的2倍，但不应低于1.5倍和高于3倍，其精度：不应低于1.6级。表盘直径不应小于100mm。压力表应安装在被试验容器顶部便于观察的位置。 It shall be arranged two calibrated pressure gauges with same range according to the specified pressure in the drawing. The gauge ranger should be double test pressure, but not less than 1.5 times and nor more than 3 times. The gauge precision should be not less than class 1.6 . The gauge dial shall not less than 100mm. The gauge shall be installed at the top of the vessel to be visual. 4.2紧固件、盲板或试验压环的选用 Selection and installation of blind plate, seal parts and