Allen老师CCNA笔记.docVIP

第7课 回顾上节课中cdp相关知识 最开始R1上查看 R1 R1en R1# R1#sh cdp neighbors Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater Device ID Local Intrfce Holdtme Capability Platform Port ID R1#sh cdp neighbors Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater Device ID Local Intrfce Holdtme Capability Platform Port ID R1#sh cdp neighbors Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater Device ID Local Intrfce Holdtme Capability Platform Port ID R1# R1# 发现在R1上无法查看到和它相连的R2设备 R1#sh ip interface FastEthernet0/0 is administratively down, line protocol is down Internet protocol processing disabled 发现接口都是down的 R1#conf t Enter configuration commands, one per line. End with CNTL/Z. R1(config)#in f 0/0 R1(config-if)#no shut 配置接口为no shut R1(config-if)# R1(config-if)#^Z R1# R1# *Mar 1 00:01:56.611: %SYS-5-CONFIG_I: Configured from console by console R1# *Mar 1 00:01:57.099: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up *Mar 1 00:01:58.099: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up R1# R1# R1#sh ip interface FastEthernet0/0 is up, line protocol is up Internet protocol processing disabled 这时接口都是up的 R1#sh cdp neighbors Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater Device ID Local Intrfce Holdtme Capability Platform Port ID R2 Fas 0/0 143 R S I 3640 Fas 0/0 R1# R1# R1# R1#sh cdp neighbors detail Device ID: R2 Entry address(es): Platform: Cisco 3640, Capabilities: Router Switch IGMP Interface: FastEthernet0/0, Port ID (outgoing port): FastEthernet0/0 Holdtime : 141 sec