measuring leveling ruler at both ends.docVIP

measuring leveling ruler at both ends; (12) plates to allow the difference of diagonal deviation of 10 mm, inspection method for steel rule of two diagonal lines; (13) wallboard diagonal difference is 5 mm, the allowable deviation inspection method for steel rule of two diagonal lines; (14) to allow the reserved hole centerline deviation is 5 mm, test method for the feet; Reserve only electives (15) to allow the size deviation of plus or minus 5 mm, test method for the feet; (16) to allow the reserved hole centerline deviation to 10 mm, test method for the feet; (17) to allow the reserved hole hole size deviation of plus or minus 10 mm, test method for the feet; (18) embedded parts embedded plates to allow the centerline position deviation is 5 mm, test method for the feet; (19) embedded parts and concrete surface plane the allowable deviation of the elevation difference is + 5 mm, test method for the feet; (20) embedded bolt, embedded sleeve position at the centre of the allowable deviation of 2 mm, test method for the feet; (21) embedded bolts exposed length of allowable deviation of + 10, 3-5 mm, test method for inspection. 5, the embedded parts on the prefabricated, steel reserve, buries the line and the reserved hole specification, location and quantity should meet the design requirements. 6, the combination of prefabricated surface should comply with the design requirements. Installation and connection of [3] 1, the prefabricated connection between structure should meet the design requirements. 2, bear the joint and flat-fell seam of internal force, when the concrete strength did not meet the design requirements, shall not be lifting a layer structures. Have installed fabricated structure, should be after the concrete strength to meet the design requirements, can withstand all the design load. 3, prefabricated structure after the installation, size deviation shall meet the following requirements. Based component (1) the centerline to allow the