Lateral beam template parameters.doc

Lateral beam template parameters: 1, the beam breadth: 400 mm 2, beam height: 600 mm 3, floor thickness: 100 mm 4, template materials: plywood 5, the thickness of the template: 15 mm 6, beam side wood square root number, root 7, wood square section specifications: 50 * 80 mm 8, wood square distance: 265 mm 9, selection of the main keel: double steel pipe (no more than 10, the main keel spacing) : 450 mm 11, the bolt diameter: 14 mm 12, the bolt number: 1 13, the vertical distance between bolt: / 14, the first line of bolts from the bottom of the beam: 250 mm 15, the bolt spacing () with the main keel span direction: 450 mm 16, beam side span: do not set inclined support Height 4500:400 x 400 template figure 400 x 700 beam, the height of 4.5 m templates support figure parameter list: The basic parameters, structure: 1, the beam breadth: 400 mm 2, beam height: 700 mm 3, floor thickness: 100 mm 4, the height: 4.5 m Second, the beam bottom formwork supporting parameters: 1, bearing frame selection: steel fasteners 2, bearing frame supported way: beams under double top stud 3, the beam end of bearing poling number: 2 4, template materials: plywood 5, the thickness of the template: 15 mm 6, beam bottom wood square root number: 3 7, wood square section specifications: 50 * 80 mm 8, beam bottom wood square distance: 175 mm 9, small beam bottom bar: phi 48 x 3.5 steel pipe 10, small bar spacing: 500 mm 11, beam side stud space: 1 m 12, beam side span poling direction space (less than) : 1 m 13, poling basis: 50 mm thick concrete floor with wooden planks 14, Max tonetto jacking beam type: no beam 15, beam bottom rod span direction spacing (less than) : 1 m 16, beam bottom rod transverse spacing: 0.33 m 17, horizontal bar interval: 1.5 m 18, the top plate under 2 level step length is adjusted for: 1.1 m 19, level rod assembly steps (including sweep the floor and at the top of the encryption area, do not contain additional levels under beam) : step 4 20, sweeping stem from the