中文 RCB II.docVIP

Ring Car Board II With OCSS Group 1: General OCSS No. Symbol Initial Setting Purpose and Range 1-1 RCB-NO 1 Car Identifier 电梯梯号设置 1 to 8 = 梯号 A to H Car identifier in group. 在群控下状态下电梯的识别号。 1-2 EN-CON 0 Enable Contract Software 选择用于旧梯改造时的特别软件 0 = disable contract software 起效 1 = enable contract software 不起效 Determines if the contract software, contained in the contract EPROM chips, should be executed. 1-3 EN-EMO 0 Enable Overlay Controller Functionality 0 = disable overlay controller functionality 不起效 1 = enable overlay controller functionality 起效 This parameter should be enabled when the OCSS resides on an EMO or TEMO. Once a full MOD controller is in place; for example, an E411M or E311M controller, this parameter should be disabled. 1-4 SVT-PO 1 Service Tool Position Offset 服务器楼层位置起始设置 0 = service tool positions start at landing 0 起始层从0楼开始 1 = service tool positions start at landing 1 起始层从1楼开始 Specifies whether positions are displayed on the Service Tool starting at landing 0 or landing 1. 决定服务器的楼层显示从0楼或者从1楼开始。 1-5 #RINGS 1 Number Of Rings Used For Communication 选择群控环的数量（2个环影响扫描时间） 1 = Use one ring for most communication to save CPU 使用一条控环 2 = Use two rings for all communication 使用二条群控环 This variable specifies the number of rings to be used by the OCSS’s to communicate with each other. 1-6 R-BAUD 192 Ring Communications Baud Rate （RCB板通信波特率设置 96 = 9600 baud 192 = 19200 baud（必需是192） Defines baud rate used for ring communications. Note that all the cars in the group must have the same ring communications baud rate. Also note that the controller power must be cycled for the change to take affect. 1-7 EMS-O PL******EMS Options 电梯管理系统选择 P bit = 0: disable EMS parameter passing P bit = 1: enable EMS parameter passing L bit = 0: transmit OCSS load states using ICD 4.1 or lower L bit = 1: transmit OCSS load states using ICD 4.2 or higher Systems with EMS v2.0 or lower must have parameter passing disabled. Systems with an EMS configured