外文翻译(模板)外文翻译(模).doc

毕业设计外文文献翻译 院 系： 电子与电气工程系 年级专业： 2010级电气工程及其自动化 姓 名： 韩孟涛 学 号： 102032118 附 件： Automatic fire alarm system based on MCU 指导老师评语： 文献翻译总体完成质量较好，所选取的外文文献与毕业设计内容相近，正文的字数、格式等也都基本符合学院要求，但有些段落的翻译不够准确。 指导教师签名： 2014年1月10日 Automatic fire alarm system based on MCU 【ABSTRACT】The paper introduced an automatic warehouse fire a1arm system based on MCU. The system was mainly made up of ATmega16, temperature sensors, smoke sensors, and EX-1 auto dialed alarm module. In the system, temperature signals were transformed to serial data, and smoke signals were transformed to voltage signals. All the data were processed by MCU. When the surveillance system checked fire in warehouse, alarm signal was turn on, meanwhile the messages were transmitted to managers through EX-1. Application of the system was convenient to deal with fire in-time, efficiently by warehouse manager. 【Key Words】fire alarm transducersmoke sensor system，ATmega16 I. INTRODUCTION Automatic fire alarm control system has experienced a process from the simple to the complex and intelligence system increasingly in China. The characteristic is automatic fire detection and alarm technology has a great progress along with computing and detection technology development. At present, automatic fire alarm control system was used in bulk storage plant, shopping malls, high-level office buildings, hotels and other places. They were used in a number of collections focused on one area of intelligent alarm control method with higher levels of bus-type alarm control system, and in some residential areas and commercial buildings were installed by a single automatic fire alarm detection device. These alarm detection devices fail to report sometimes, or misinformation. Its reliability is not high because of using single sensor. Therefore, it is needed to develop a simple structure, low cost, high reliability, fast responding, automatic fire detection system. II. GENERAL PROJECT OF THE SYSTEM The hardware bl