电子科技大学集成电路实验报告版图部分实验报告..doc

微电子与集成电路设计 实验报告 使用L-Edit编辑单元电路布局图 一、实验学时：4学时 二、实验目的 1、熟悉版图设计工具L-Edit的使用环境； 2、掌握L-Edit的使用技巧。 三、实验内容：利用L-Edit绘制一个反相器的版图，并利用提取工具将反相器布局图转化为T-Spice 文件。 四、实验结果： 1、本次版图设计中的设计技术参数、格点设定、图层设定、设计规则采用的是（ C:\TannerLb\LEdit\TECH\mosis\morbn20.tdb ）文件的。 其设计规则主要有： Rule（设计规则） Rule Type （规则类型） Rule Layers （对应层） Rule Distance 1.1 Well Minimum Width Minimum Width N well 10 lambda 1.3 Well to Well(Same Potential) Spacing Spacing N well 6 lambda 2.1 Active Minimum Width Min width Active 3 lambda 2.2 Active to Active Spacing Spacing Active 3 lambda 2.3a Source/Drain Active to Well Edge Surround Pdiff , N well 5 lambda 2.3b Source/Drain Active to Well Space Spacing Ndiff , N well 5 lambda 2.4a WellContact(Active) to Well Edge Surround N Active ,N well 3 lambda 2.4b SubsContact(Active) to Well Spacing Spacing P active,N well 3 lambda 3.1 Poly Minimum Width Min width Poly 2 lambda 3.2 Poly to Poly Spacing Spacing Poly 2 lambda 3.3 Gate Extension out of Active Extension Active,Poly 2 lambda 3.4a/4.1a Source/Drain Width Extension Poly or ploy2,n active 3 lambda 3.4b/4.1b Source/Drain Width Extension Poly or ploy2,p active 3 lambda 3.5 Poly to Active Spacing Spacing Poly,Active 1 lambda 4.2a/2.5 Active to N-Select Edge Surround Active not in NPN,N Select 2 lambda 4.2b/2.5 Active to P-Select Edge Surround Active not in NPN,P Select 2 lambda 4.3a Select Edge to ActCnt Surround Active contact,ndiff 1 lambda 4.3b Select Edge to ActCnt Surround Active contact,pdiff 1 lambda 4.3c Not Exists: ActCnt not on Active Not exist ActCnt_not_on_act \ 4.4a NSelect Minimum Width Min width N Select 2 lambda 4.4b PSelect Minimum Width Min width P Select 2 lambda 4.4c Select to Select Spacing Spacing N Select 2 lambda 4.4d Select to Select Spacing Spacing P Select 2 lambda 4.5 Not Existing: pSel Overlap of nSel Not exist pSelectnSelect \ 4.6 Not Existing: Not Selected Active Not exist Not Selected Active \ 5.1A Poly Contact Exact Size Exact