电动车取电系统设计汇编.docVIP

毕业论文（设计） 小区电动车无线取电系统的设计 学 院： 广陵学院 专 业： 机械电子工程系 班 级： 信科80901 学 号： 090012111 学生姓名： 李亚苹 指导教师： 朱金荣 小区电动车无线取电系统的设计 信科80901 李亚苹 指导老师：朱金荣 摘要 本课题所研究的小区电动车无线取电系统的设计，就是为了解决目前小区电动车充电难的问题而提出的具体设计方案，该系统主要分为3个部分无线发射模块、无线接收模块和主控制模块。 本文采用了一种新型的无线编码芯片EV1527在无线发射模块中的应用，通过天线发送编码信号给接收模块；接收模块通过无线接收芯片SYN480R接收信号，再将信号传送给主控制芯片STC12C2052AD单片机；然后通过STC12C2052AD单片机控制继电器的通与断，从而来控制电动车的充电情况；同时电动车充满电后亦可自行断电，需要再次接通电源必须要有与之配套的无线遥控器操作。因此小区电动车无线取电系统的设计使得电动车的充电更加方便管理，并且可以节约能源，具有一定的市场前景。 关键词：STC12C2052AD；EV1527；SYN480R；继电器 Abstract The subject studied cell electric vehicles take power wireless system design, is proposed in order to solve the difficult problem of the current cell electric vehicle charging design, the system is divided into three parts wireless transmitter modules, wireless receiver modules and main control modules. In this paper, a new type of wireless encoder chip ev1527 wireless transmitter module antenna to send a coded signal to the receiver module; the receiver module the wireless receiver chip syn480r of the received signal, and then the signal is sent to the main control chip stc12C2052AD microcontroller; through stc12C2052AD single-chip control relay on and off, to control electric car charging; electric car is fully charged can also power on their own, again connected to the power supply must have a complete set of wireless remote control operation. Take power cell electric vehicle wireless system design makes the charging of electric vehicles more convenient management, and energy conservation, has a certain market prospects. Key words: STC12C2052AD; EV1527; SYN480R; Relay 目录 摘要.……………………………………………………………………………..….….1 Abstract……………………………………………………………………………..….2 第一章 绪论……...……...…...……...………...……...………...……………...…..….4 课题背景…..………………………………………………………………..…..4 课题研究的目