大学毕业论文--切边冲孔复合模的设计与制造.docVIP

摘 要 该模具用于生产杯形件，完成切边冲孔复合工序，压力机选用J23-10,他的工作原理是：将拉伸后的半成品件放入模具内，用定位销钉定位，在压力机的作用下合模，将工件压入凹模内完成冲孔切边工序。开模后，工件留在下模上通过推杆和弹簧将工件推出。 关键字：复合，定位销钉，推杆 Abstract The mould parts used in the production of glass, trimming punching machine selection process, composite, they - 10 working principle is: will stretch of semi-finished parts in after the mould, with positioning pin in the press, under the influence of the mould, the workpiece will finish the punching trimming dies. Open mode, workpiece leave next modules by putting out the workpiece and spring Keywords: Compound, positioni