P-100-Annex_A1.docVIP

|Design data Unit Required regularity % Design operating life years Design data for the production and test manifold Condition Unit Number of production wells Production rate per well gas/liquid : Sm3/d Max. gas case Max. liquid case Wellhead shut-in pressure bara * max. * min. Flowing wellhead pressure bara * max. * min. Flowing wellhead temperature oC * max. * min. Sand production g/hr Specified conditions for transport of the following fluids at the well service manifold(s) Fluid Unit Quantity Condition Well production (backflow from wells) Sm3/d Water-based mud m3/d Brine m3/d Diesel m3/d Methanol m3/d Chemicals m3/d Other m3/d  Interface requirements list Utility Unit Quantity Condition Instrument air Sm3/hr Electric power kW Brine m3/hr Diesel m3/hr Methanol m3/hr Hydraulic power kW Mud m3/hr  Design data Process variable Unit Value Required regularity % Design operating life years Inlet/wellstream conditions Condition Unit Wellhead/inlet pressure bara * max. * min. Wellhead/inlet temperature oC * max. * min. Sand production g/hr Separators and coaleshers Process variable Unit Value Design pressure/temperature max. / min. barg / °C Operating pressure/temperature barg / °C Inlet conditions: Design flowrate kg/h Composition Density kg/m3 Dynamic viscosity Ns/m2 Vapour outlet conditions: Design flowrate kg/h Composition Density kg/m3 Dynamic viscosity Ns/m2 Molweight MW Compressibility Liquid outlet conditions: Design flowrate kg/h Composition Density kg/m3 Dynamic viscosity Ns/m2 Water outlet conditions: Design flowrate kg/h Composition Density kg/m3 Dynamic viscosity Ns/m2  Heat Exchangers Process variable Unit Value Hot side: Fluid description Temperature inlet/outlet °C Flow kg/h As for separator inlet Minimum skin