液壓外文翻译英文部分.docVIP

Facilities Available in Run Mode 1 Introduction In run mode you can: Specify the characteristics of simulation runs. Initiate these simulation runs. Plot graphs of the results. Specify linear analysis to be performed at various times. Post-process the linear analysis results. Post-process activity index results. Start the design exploration control panel and perform design export studies. Start the export parameters control panel and create export files. There are a large number of special icons in run mode as shown in Figure 1 Figure 1: Icons available in Run mode 2 Time domain and linear analysis modes When you click on component or line run, AMESim behaves differently if Time domain mode or Linear analysis mode is currently selected. If Linear analysis mode is selected a group of special icons are displayed. In Time domain mode you can plot graphs. This activity involves AMESim reading the reading the results files from either a standard run or a batch run.In Linear analysis mode you can: Set the characteristics for linear analyses to be done during next run. Look at eigenvalues. Do Bode,Nyquist and Nichols plots. Examine modal shapes. Do a root locus plot. This involves AMESim reading .jac(Jacobian) files.In both modes run parameters can be set and runs initiated. 3 Running a simulation To run a simulation： If necessary, change the Save status and Locked status of variables. If necessary, change the linear analysis status of variables. Set the run parameters to define the characteristics of the run. To do this click on the Run parameters button to puoduce the Run Parameters dialog box. Initiate the run by clicking on the Start run button.When the run starts,a Simulation run dialog box appears. 3.1 Save status and Save next status of variables If the Save next status of a variable is true,during the next run its value will be added to the .results file. The Save next status of variables does not in any way influence linear analysis results. Th